Makita BHR162 Bedienungsanleitung PDF herunterladen (Seite 12)

Wiring diagram

P 12/ 12

Connector

lead wire holder

lead wire holder

lead wire holder

LED

Connecting terminal

rib

Terminal side

Switch side

With the lead wire (orange) to Connector

positioned on the Terminal installation side,

fix Light circuit with the holder.

Light circuit

Lead wire

(orange)

Connector

Flag connector

rib

Light circuit

Terminal

Switch

Endbell

Yoke unit

FET

Fig. 39

Flag connector

Terminal

Wire connecting portion

Pole mark

Connecting Controller's Lead Wires to Terminal

The Flag connector has to be so connected

that the wire connecting portions are positioned

on the side of pole marks of Terminal.

Route the following lead wires

between rib and Light circuit.

*Connecting lead wire (blue) between

Switch and Connector

*Lead wires (red, black) between

Terminal's flag connector and Connector

FET Lead wire (black)

FET Lead wire (blue)

FET Lead wire (yellow)

Fix the three lead wires of FET

(black, blue, yellow from Switch

trigger side) with the lead wire

holders on Switch.

Route three FET lead wires

(black, blue, yellow) between

rib and Connecting terminal.

Connect the Connector of

Light circuit with that of Switch.

Then fix them in these holders.

Be sure to fix all the lead wires

of each Connector by routing

through the slits in the holders.

Fix LED Lead wires (black, red)

with the lead wire holder.

1 2 ... 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare