PUMP MODEL : EW1 OOR INSTRUCTION MANUAL 1 ISSUEEMD-PU0945 I
6. STOPPING THE ENGINE 1. Set the speed control lever to the low speed position and allow the engine to run at low speed for 2 or 3 m
DAILY INSPECTION lhours (daily) 0 (daily) Clean engine and check bolts and nuts. Clean spark plug. Clean air cleaner. Before running the pump, check t
0. "HOW-TO" MAINTENANCE INSPECTING THE SPARK PLUG Clean off carbon deposits on the plug electrode using a plug cleaner or wire bru
CHECKING BOLTS, NUTS AND SCREWS Retighten loose bolts and nuts. Check for fuel and oil leaks. Replace damaged parts with new ones. Keep safety on your
Pump does not run. I Pumping volume is small. -r Pump does not self-prime. Engine does not start. (See page 13.) Sticking of impeller (Disassemble and
WHEN ENGINE DOES NOT START: fore you take the pump to your Makita dealer. If you still have trouble after com- pleting the checks, take the pum
IO. PREPARATIONS FOR STORAGE Drain all water from the drain plug. [CAUTION m When retightening drain plug, be sure to clean the drain plug and the
MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted
Thank you for purchasing a Makita water pump. This manual covers operation and maintenance of water pumps. All information in this publication is
~~ ~~ ~ Please make sure you review each precaution carefully. SURROUNDINGS m Operate the pump on a stable, level surface free of small rocks, loose
2. COMPONENTS Speed control lever Plug(priming) \ Delivery Fuel tank , Chokelever Suction Plug(drain)’ Hose coupling -2-
3. PREPARATIONS FOR STARTING 1. Connect the suction hose. Use a reinforced-wall or wire braided hose to prevent suction collapse. Since the pump’s s
4. Check the prlming water. It is recommended that the water chamber of pump casing should be primed with full of water before operating. +CAUT
4. STARTING THE ENGINE 1. Open the fuel cock. 2. Set the speed control lever to “START.” 3. Close the choke lever. If the engine is warm or the ambien
4. Pull the starter handle slowly until re- sistance is felt. This is the "compression" point. Return the handle to its original
5. OPERATION Avoid operating the engine at high speed for a long time without load. 1. After starting the engine, gradually open choke by turning t
Kommentare zu diesen Handbüchern