Makita JR3000V Spezifikationen PDF herunterladen (Seite 7)

Installing or removing saw blade

CAUTION:

• Always clean out all chips or foreign matter adhering to

the blade, blade clamp and/or slider. Failure to do so

may cause insufficient tightening of the blade, resulting

in a serious injury.

To install the blade, loosen the screw on the blade clamp with

the hex wrench. Insert the blade between the blade clamp

and the slider so that the pin on the slider fits into the hole in

the blade shank. If the pin cannot easily fit into the hole,

remove the hex wrench from the screw and then try again.

After the pin fits properly into the hole, tighten the screw

clockwise securely while making sure that the blade cannot

be extracted even though you try to pull it out.

CAUTION:

• If you tighten the screw without the pin on the slider

fitting properly in the hole in the blade shank, the pin or

the blade shank will be damaged. This may cause the

blade to be extracted unexpectedly during operation.

To remove the blade, follow the installation procedure in

reverse.

OPERATION

CAUTION:

• Always press the shoe firmly against the workpiece

during operation. If the shoe is held away from the

workpiece during operation, strong vibration and/or

twisting will be produced, causing the blade to snap

dangerously.

• Always wear gloves to protect your hands from hot flying

chips when cutting metal.

• Be sure to always wear suitable eye protection which

conforms with current national standards.

• Always use a suitable coolant (cutting oil) when cutting

metal. Failure to do so will cause premature blade wear.

1. Screw

2. Hex wrench

002503

1. Slider

2. Pin

3. Blade clamp

4. Screw

5. Blade

6. Hole

002509

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Makita JR3000V Spezifikationen Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kreissägen Makita JR3000V