Makita JR102D Bedienungsanleitung PDF herunterladen (Seite 12)

Switch

trigger

Switch trigger side

Now, Switch can be mounted to Housing (L) as drawn in Fig. D-5.

Line filter location

when it is used.

Store Switch lead wire (red) to Terminal

within the Terminal’s width designated

with dotted lines.

Housing (L)

Pass the Lead wires (black, red) between

DC motor and Switch through Line filter

when it is used.

And put the Line filter to this place.

Fig. D-5

Wiring of Lead wires of DC Motor, Switch, Terminal in Housing (L)

Route Lead wires (white, black) from

connector to this place and store them

in this place.

DC Motor

Fig. D-3 Fig. D-4

Wiring to DC Motor

Wiring to Terminal

Assemble DC Motor to Housing (L),

* the Lead wires must be faced to Housing (R) side.

* the Lead wire (black) must be located to the Switch trigger side.

Connect the Lead wires to

Terminal as drawn below.

Red point mark

Housing L

side

Housing R side

Bend the Terminal with black Lead wire 30 degrees toward the center

so that the Terminal does not touch the rib for setting DC Motor.

Terminal

30 degrees

Lead wire (red)

Rib C

Rib D

Bend Terminal of DC motor inside

so as to be stored between Rib C

and Rib D.

Wiring diagram (cont.)

P 12/ 12

1 2 ... 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Makita JR102D Bedienungsanleitung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kabellose Kettensägen Makita JR102D