Makita RJ01W Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 6)

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and the

battery cartridge is removed before carrying out

any work on the tool.

Installing or removing the saw blade

CAUTION:

• Always clean out all chips or foreign matter

adhering to the blade, blade clamp and/or slider.

Failure to do so may cause insufficient tightening of

the blade, resulting in a serious injury.

012161

Insert the recipro saw blade into the blade clamp as far

as it will go. The blade clamp sleeve rotates and the saw

blade is fixed. Make sure that the saw blade cannot be

extracted even though you try to pull it out.

CAUTION:

• If you do not insert the saw blade deep enough, the

saw blade may be ejected unexpectedly during

operation. This can be extremely dangerous.

012162

To remove the saw blade, rotate the blade clamp sleeve

in the direction of the arrow fully. The saw blade is

removed and the blade clamp sleeve is fixed at the

released position.

NOTE:

• If you remove the saw blade without rotating the

blade clamp sleeve fully, the sleeve may not be

fixed. In this case, rotate the blade clamp sleeve

fully, then make the sleeve fixed at the released

position.

OPERATION

012171

CAUTION:

• Always press the shoe firmly against the workpiece

during operation. If the shoe is held away from the

workpiece during operation, strong vibration and/or

twisting will be produced, causing the blade to snap

dangerously.

• Always wear gloves to protect your hands from hot

flying chips when cutting metal.

• Be sure to always wear suitable eye protection

which conforms with current national standards.

• Always use a suitable coolant (cutting oil) when

cutting metal. Failure to do so will cause premature

blade wear.

Press the shoe firmly against the workpiece. Do not allow

the tool to bounce. Bring the saw blade into light contact

with the workpiece. First, make a pilot groove using a

slower speed. Then use a faster speed to continue

cutting.

012172

012173

•

You can use the switch lever or trigger according to

your work.

1. Blade clamp

sleeve

2. Saw blade

1. Recipro saw

blade

2. Blade clamp

sleeve

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Makita RJ01W Gebrauchs- und Pflegehandbuch Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge Makita RJ01W