Makita LS1216 Bedienerhandbuch PDF herunterladen (Seite 11)

Laser beam action

For models LS1216L only

009492

CAUTION:

• Never look into the laser beam. Direct laser beam

may injure your eyes.

• LASER RADIATION, DO NOT STARE INTO THE

BEAM OR VIEW DIRECTLY WITH OPTICAL

INSTRUMENTS, CLASS 2M LASER PRODUCT.

To turn on the laser beam, press the upper position (I) of

the switch. To turn off the laser beam, press the lower

position (0) of the switch.

Laser line can be shifted to either the left or right side of

the saw blade by adjusting the adjusting screw as

follows.

009493

1. Loosen the adjusting screw by turning it

counterclockwise.

2. With the adjusting screw loosened, slide the

adjusting screw to the right or left as far as it goes.

3. Tighten the adjusting screw firmly at the position

where it stops sliding.

Laser line is factory adjusted so that it is positioned

within 1 mm from the side surface of the blade (cutting

position).

NOTE:

• When laser line appears dim and hard to see

because of direct sunlight, relocate the work area

to a place where there is less direct sunlight.

Aligning the laser line

009494

Laser line can be shifted to either the left or right side of

the blade according to the applications of cutting. Refer

to explanation titled "Laser beam action" regarding its

shifting method.

NOTE:

• Use wood facing against the guide fence when

aligning the cutting line with the laser line at the

side of guide fence in compound cutting (bevel

angle 45 degrees and miter angle right 45

degrees).

A) When you obtain the correct size on the left side of

workpiece

• Shift the laser line to the left of the blade.

B) When you obtain the correct size on the right side of

workpiece

• Shift the laser line to the right of the blade.

Align the cutting line on your workpiece with the laser

line.

ASSEMBLY

WARNING:

• Always be sure that the tool is switched off and

unplugged before working on the tool. Failure to

switch off and unplug the tool may result in serious

personal injury.

Socket wrench storage

009495

The socket wrench is stored as shown in the figure.

When the socket wrench is needed it can be pulled out

of the wrench holder. After using the socket wrench it

can be stored by returning it to the wrench holder.

1. Wrench holder

2. Socket wrench

1. Adjusting screw

1. Switch for laser

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Makita LS1216 Bedienerhandbuch Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gehrungssägen Makita LS1216