Makita 5012B Bedienerhandbuch PDF herunterladen (Seite 8)

Installing saw chain and guide

bar

CAUTION

Always be sure that the tool

switched off and unplugged before installing saw chain and

guide bar.

Use the socket wrench to toosen the hex

bolt holding the chain cover. Remove the

chain cover.

Fig.

Fit one end of the chain over the sprocket and the other over the end of the guide bar.

Notice that the cutters must be in the direction of the arrow in Fig.

and

Keep the

chain in the guide bar grooves.

Install the guide bar

that the lower hole in the guide bar

just over the adjusting pin.

Install the chain cover and tighten the hex bolt only tight enough to hold the guide bar

temporarily.

Adjusting saw chain tension

CAUTION

Always be sure that the tool

switched off and unplugged before adjusting chain tension.

Grasp the chain in the middle of the guide

bar and lift up. The gap between the side

link of the chain and the guide bar should

be about

mm to

(1/8”

5/32”).

Fig.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Keine Kommentare

Makita 5012B Bedienerhandbuch Seite 8