Power Planer PI an in g width 82 mm (3-1/4”) MODEL 1923B ~ ~~~~ __ Planing Rabbeting No load 0 vera I I Net depth depth speed (RPM) length weight
Chamfering To make a cut as shown at the right, align the "V" groove in the front base with the edge of the workpiece and plane it
Sharpening planer blades 71 Always keep your blades sharp for the best performance possible. Use the sharpening holder to remove nicks and produc
MAINTENANCE CAUTION : Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Replacing c
ACCESSORIES CAUTION : These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of
Fsb.-20-'87 EN 82 mm (3-1/4") POWER PLANER Model 1923B Note: The switch, noise suppressor and other part configurations may differ from
MODEL 19238 Mar-02 '89 US 10 11 12 'yoM A& DESCRIPTION 12 21 31 41 51 66 71 81 91 1 1 1 '7,'o" DESCRIPTION 34 35 36 37 38
c t MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warrant
IMPORTANT SAFETY INSTRUCTIONS (For All Tools) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFE- REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND PER- T
14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 15.
ADDITIONAL SAFETY RULES 1. Rags, cloth, cord, string and the like should never be left around the work 2. Avoid cutting nails. Inspect for and remov
Removing or installing planer blades CAUTION : Always be sure that the tool is switched off and unplugged before removing or installing the blade.
3. Set the adjust platehet plate on the gauge base so that the planer blade locating lugs on the set plate rest in the mini planer blade
For shiplapping, the blade edge should be made to protrude outside slightly (0.3 mm - 0.6 mm: 1/64" - 1/32"). Otherwise, nicks and gen
Adjusting depth of cut Depth of cut may be adjusted by simply turning the knob on the front of the tool. Switch action To start the tool, s
Shiplapping To make a stepped cut as shown at the right, use the edge fence. Cutting line I Adjust the edge fence until it comes in con- tact wi
Kommentare zu diesen Handbüchern