Makita LS1013L Bedienerhandbuch PDF herunterladen (Seite 15)

with the blade and PUSH THE CARRIAGE

TOWARD THE GUIDE FENCE TO CUT THE

WORKPIECE. When the cut is completed, switch

off the tool and WAIT UNTIL THE BLADE HAS

COME TO A COMPLETE STOP before returning

the blade to its fully elevated position.

CAUTION:

• Always be sure that the blade will move down to

bevel direction during a bevel cut. Keep hands out

of path of saw blade.

• During a bevel cut, it may create a condition

whereby the piece cut off will come to rest against

the side of the blade. If the blade is raised while the

blade is still rotating, this piece may be caught by

the blade, causing fragments to be scattered which

is dangerous. The blade should be raised ONLY

after the blade has come to a complete stop.

• When pressing down the handle, apply pressure in

parallel with the blade. If a force is applied

perpendicularly to the turn base or if the pressure

direction is changed during a cut, the precision of

the cut will be impaired.

• Always set the sub-fence to the left position when

performing left bevel cuts.

5. Compound cutting

Compound cutting is the process in which a bevel

angle is made at the same time in which a miter

angle is being cut on a workpiece. Compound

cutting can be performed at angle shown in the

table.

Miter angle Bevel angle

Right 52

Left 0 - 47 , Right 0 - 45

Left and Right 0 - 45

Left 0 - 40 and Right 0 - 45

006360

At the miter angle of left 45° and bevel angle of left

45°, workpieces up to 50 mm high and 200 mm

wide can be cut.

At the miter angle of right 45° and bevel angle of

left 45°, workpieces up to 50 mm high and 215 mm

wide can be cut.

At the miter angle of left and right 45° and bevel

angle of right 45°, workpieces up to 31 mm high

and 215 mm wide can be cut.

When performing compound cutting, refer to

"Press cutting", "Slide cutting", "Miter cutting" and

"Bevel cut" explanations.

6. Cutting aluminum extrusion

001561

004073

When securing aluminum extrusions, use spacer

blocks or pieces of scrap as shown in the figure to

prevent deformation of the aluminum. Use a

cutting lubricant when cutting the aluminum

extrusion to prevent build-up of the aluminum

material on the blade.

CAUTION:

• Never attempt to cut thick or round aluminum

extrusions. Thick aluminum extrusions may come

loose during operation and round aluminum

extrusions cannot be secured firmly with this tool.

7. Groove cutting

001563

A dado type cut can be made by proceeding as

follows:

Adjust the lower limit position of the blade using

the adjusting screw and the stopper arm to limit the

cutting depth of the blade. Refer to "Stopper arm"

section described previously.

After adjusting the lower limit position of the blade,

cut parallel grooves across the width of the

workpiece using a slide (push) cut as shown in the

1. Cut grooves with

blade

1. Aluminum

extrusion

2. Guide fence

3. Spacer blocks

4. Horizontal vise

(optional

accessory)

1. Guide fence

2. Vise

3. Spacer block

4. Aluminum

extrusion

5. Spacer block

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Makita LS1013L Bedienerhandbuch Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gehrungssägen Makita LS1013L