Makita 3707FC Bedienungsanleitung

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comT

10Attach the guide plate to the straight guide with the bolt, thewave washer, the flat washer and the wing nut.Attach the straight guide with the clam

11For cutting circles between 70 mm (2-3/4”) and 121 mm (4-3/4”) in radius.For cutting circles between 121 mm (4-3/4”) and 221 mm (8-11/16”) in radius

12Trimmer guideTrimming, curved cuts in veneers for furniture and the likecan be done easily with the trimmer guide. The guide rollerrides the curve a

13Replacing carbon brushesRemove and check the carbon brushes regularly. Replacewhen they wear down to the limit mark. Keep the carbonbrushes clean an

Memo14

Memo15

Memo16

17First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut

181. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )

19FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSALABAMA2365 Pelham ParkwayPelham, AL 35124 (205) 620-1791ARIZONA3707 E. Bro

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif

35. Avoid body contact with grounded sur-faces such as pipes, radiators, ranges andrefrigerators. There is an increased risk ofelectric shock if your

4SERVICE23.Tool service must be performed only byqualified repair personnel. Service or main-tenance performed by unqualified personnelcould result in

59. Before using the tool on an actual work-piece, let it run for a while. Watch forvibration or wobbling that could indicateimproperly installed bit.

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Adjusting

7NOTE:• Use a dry cloth to wipe the dirt off the lens of light. Becareful not to scratch the lens of light, or it may lower theillumination.ASSEMBLYCA

8NOTE:• Moving the tool forward too fast may cause a poorquality of cut, or damage to the bit or motor. Moving thetool forward too slowly may burn and

9Loosen the screws and remove the base protector. Place thetemplet guide on the base and replace the base protector.Then secure the base protector by