Makita 2708 Bedienerhandbuch PDF herunterladen (Seite 8)

008770

CAUTION:

• The ring 25.4 mm in outer diameter is

factory-installed onto the spindle.

• Keep the flange surface clean of dirt or other

adhering matter; it could cause blade slippage. Be

sure that the blade is installed so that the teeth are

aligned in the cutting (turning) direction.

To secure the blade in place, hold the outer flange with

the offset wrench, then tighten the hex nut clockwise

with the wrench. BE SURE TO TIGHTEN THE HEX NUT

SECURELY.

008771

CAUTION:

• Be sure to hold the hex nut carefully with the

wrench. If your grip should slip, the wrench may

come off the hex nut, and your hand could strike

the sharp blade edges.

Installing blade guard

009029

009030

CAUTION:

• Before installing the blade guard, adjust the depth

of cut to its maximum elevation.

Remove the center cover. Insert the riving knife into the

blade guard mounting portion (stay). Tighten the hex

bolts (A) with the provided wrench.

The riving knife installing location is factory-adjusted so

that the blade and riving knife will be in a straight line.

However, if they are not in a straight line, loosen the hex

bolts (B) and adjust the blade guard mounting portion

(stay) so that the riving knife is aligned directly behind

the blade. Then tighten the hex bolts (B) to secure the

stay.

008776

CAUTION:

• If the blade and riving knife are not aligned properly,

a dangerous pinching condition may result during

operation. Make sure they are properly aligned.

You could suffer serious personal injury while using

the tool without a properly aligned riving knife.

• NEVER make any adjustments while tool is

running. Disconnect the tool before making any

adjustments.

There must be a clearance of about 4 - 5 mm between

the riving knife and the blade teeth. Adjust the riving

knife accordingly and tighten the hex bolts (A) securely.

Attach the table insert on the table, then check to see

that the blade guard works smoothly before cutting.

1. Blade

2. These two

clearances

should be equal.

3. Blade guard

mounting portion

(stay)

4. Riving knife

5. Hex bolts (A)

6. Hex bolts

(

)

1. Blade guard

2. Riving knife

1. Blade guard

2. Riving knife

3. Blade guard

mounting

portion (stay)

1. Wrench

2. Wrench

1. Inner flange

2. Ring

3. Saw blade

4. Outer flange

5. Hex nut

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Makita 2708 Bedienerhandbuch Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge Makita 2708