Cordless Driver Drill Capacities Steel Wood Wood screw Machlne screw 10" 21" 6.4mmx55mm 6mm,1,4,,) (318'7 (13/16"1 1114"
Hook A hook is provided as a standard equip- ment. This hook is convenient for tem- porarily hanging the tool. To install the hook, first
MAINTENANCE CAUTION : Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or
ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other acc
CORDLESS DRIVER DRILL Model 6211D Note: The switch and other part configurations may differ from country to country. 13
'LtM DESCRIPTION :tM ASD DESCRIPTION MACHINE 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 10 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 1 7 1 1 2 1 1 1
The only way to dispose of a Makita battery is to recycle it. The law prohibits any other method of disposal. 1 Ni-Cd I To recycle the battery: 1.
I M PO RTA N T SAFETY INSTRUCTIONS (For All Tools) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE
14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 15
IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER & BATTERY CARTRIDGE I. SAVE THESE INSTRUCTIONS - This manual contains important safety and operating
ADDITIONAL SAFETY RULES FOR CHARGER & BATTERY CARTRIDGE 1. Do not charge Battery Cartridge when temperature is BELOW 10°C (5OOF) 2. Do not atte
Installing or removing battery cartridge 0 Always switch off the tool before insertion or removal or the battery cartridge. 0 To remove the battery c
Installing or removing driver bit or drill bit CAUTION : Always be sure that the tool is switched off and the battery cartridge is removed before in
Speed change To change the speed, slide the speed change lever to the "H" side for high speed or "L" side for low speed.
When driving wood screws, predrill pilot holes to make driving easier and to pre- vent splitting of the workpiece. See the chart. Nominal di
Kommentare zu diesen Handbüchern