INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comD
10Use a screwdriver to remove the brush holder caps. Take outthe worn carbon brushes, insert the new ones and securethe brush holder caps.LubricationT
11To maintain product SAFETY and RELIABILITY, repairs, anyother maintenance or adjustment should be performed byMakita Authorized or Factory Service C
13First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut
141. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )
15FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSALABAMA2365 Pelham ParkwayPelham, AL 35124 (205) 620-1791ARIZONA3707 E. Bro
WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif
2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S
36.Do not expose power tools to rain or wetconditions. Water entering a power tool willincrease the risk of electric shock.7.Do not abuse the cord. Ne
424.When servicing a tool, use only identicalreplacement parts. Follow instructions inthe Maintenance section of this manual.Use of unauthorized parts
5tion. Without proper warm-up, hammeringoperation is difficult.7.Always be sure you have a firm footing.Be sure no one is below when using thetool in
6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Switch act
7Indicator lampFor HM1202C onlyThe green power-ON indicator lamp lights up when the tool isswitched ON. If the indicator lamp is lit but the tool does
8Installing or removing the bitClean the bit shank and apply bit grease before installing thebit.Insert the bit into the tool. Turn the bit and push i
9OPERATIONChipping/Scaling/DemolitionHold the tool firmly with both hands. Turn the tool on andapply slight pressure on the tool so that the tool will
Kommentare zu diesen Handbüchern