Makita M432 Bedienerhandbuch

MODEL M432 Length of stroke 18 mm (11116") INSTRUCTION MANUAL Strokes Overall Net Max. cutting capacities per minute length weight in wood

Using circular guide 1. Use of the circular guide insures clean, smooth cutting of circles (radius; under 200 mm; 7-7/8") and arcs. Circular g

The underside of the work can be greased instead of using a coolant. (Fig. 18) I Fig. 18 11

MAINTENANCE CAUTION : Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. The carbon b

ACCESSOR1 ES No. - No 2 -b CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual, T

Feb 16 ‘85 EN JIG SAW mum Model M432 Note The switch. noise suppressor and other part configurations may differ from country to country 14

MODEL M432 ILLM ,"!, DESCRIPTION Feh 16 85 US ILLM DESCRIPTION MACHINC I1 21 41 51 6. I 72 3~ 2 81 2 9: 1 IO 1 I1 1 12 1 13 , 1 14 , 1 15 ~ 1 16

P MAKITA TWO YEAR LIMITED WARRANTY FOR HOME USE ONLY Every Makita tool IS thoroughly inspected and tested before leaving the factory It is warranted

IMPORTANT SAFETY INSTRUCTIONS (For All Tools) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFE- REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND PER-

14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turn- ing it on. 1

ADDITIONAL SAFETY RULES 1. Avoid cutting nails. Inspect for and remove all nails from the workpiece before 2. Don't cut hollow pipe. 3. Do

HOW TO USE Mounting Makita jig saw blade First, use the hex wrench to remove the bolt which secures the blade clamp to the blade holder shaf

3. Now attach the universal blade clamp to 1 the blade holder (blade in place) so that the spring pin fits into the hole on the blade holder. Tigh

Switch action Tool speed is increased by increasing pres- sure on the trigger. To start the tool, simply pull the trigger. Release the trigger to st

Front flush cuts Loosen the bolt on the back of the base with the hex wrench, then slide the base backwards. Check the contact between the b

Finishing edges To trim edges or make dimensional adjust- ments, run the blade lightly along the cut edges. For smoother cutting of plywoods or ot